As the title says gang. I've bought a lot of Pathfinder PDF's from RPGNow.com and I'm looking to get them printed up. I bought a Brother Black & White Dual Side Document printer and now I'm trying to figure out a good weight of paper to print them out on!

110 is great for models and terrain... but is too heavy for books.

How I'm doing all of these books: Printing them out B&W, tri-punching holes, putting them in 3 Tang Fastener folders. Labeling them with a blank sticker on the front.

Any advice would be appreciated. I don't want to buy 10 different types of stock before finding out the last one was best. Gets rather expensive!

Thanks for your input gang!

24lb. it is!

Get big binders. I just printed out the pathfinder stuff recommended for the Pathfinder Society and it took a 3.5 inch binder to hold all of it. Standard printer paper, double sided print. It works out real well. If you are going to use much heavier paper then the cost will start to approach what it would have cost to just buy the manuals.