Thanks for the review HP...and sorry to hear about your computer woes ..hope they get fixed soon.
So far (touch wood) my blade seems to be doing fine...but when it starts playing up i shall look into this myself
| WorldWorksGames http://worldworksgames.com/forum/ |
|
| Craft Robo Blade Holder GR-01 http://worldworksgames.com/forum/viewtopic.php?f=62&t=8488 |
Page 1 of 1 |
| Author: | Highland_Piper [ 06-20-2010, 04:39 AM ] |
| Post subject: | Craft Robo Blade Holder GR-01 |
I just ordered the I will give everyone a full review on it as soon as I get it. Replacement blades are only £9.00 so I thought I would go ahead and take a gamble on it. |
|
| Author: | Highland_Piper [ 06-22-2010, 11:09 PM ] |
| Post subject: | |
Craft Robo Blade Holder GR-01 works really well! You have to be extra careful placing it in as there is no marks indicating the front of the holder. Use a blank sheet of card to test out the depth of the blade. My first attempt cut into the carrier sheet! My second depth attempt worked great! I am using really thick card right now (so thick my printer has problems feeding it in at times) and the new blade had no problems cutting it. Now the only problem I have is my computer died again this morning so my plans for mass producing TLX systems is now gone until I can get it repaired AGAIN (going to use a new repair place). WARNING! Using a non Graphtec item may void your warranty. Use at your own discretion |
|
| Author: | Solospirit [ 06-22-2010, 11:34 PM ] |
| Post subject: | |
Thanks for the review HP...and sorry to hear about your computer woes ..hope they get fixed soon. So far (touch wood) my blade seems to be doing fine...but when it starts playing up i shall look into this myself
|
|
| Author: | Highland_Piper [ 06-23-2010, 03:13 AM ] |
| Post subject: | |
Well my original Craftrobo blade lasted over two years before it just was not cutting through any type of card, I just cringed at paying £30+ for a new blade. This way if these blades last even a year at the rate I cut (or would if school and computer issues did not get in the way) paying £7.50-£9.00 for a replacement blade is much more economical. |
|
| Author: | morganm [ 06-23-2010, 06:57 AM ] |
| Post subject: | |
| Author: | Highland_Piper [ 06-23-2010, 08:17 AM ] |
| Post subject: | |
| Author: | Highland_Piper [ 08-19-2010, 11:22 PM ] |
| Post subject: | |
| Author: | Highland_Piper [ 08-20-2010, 10:24 AM ] |
| Post subject: | |
| Author: | Highland_Piper [ 09-06-2010, 09:33 PM ] |
| Post subject: | |
| Author: | morganm [ 09-07-2010, 06:20 AM ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|