Apologies...I misunderstood what you were trying to say and ended up answering the wrong question. Sry
| WorldWorksGames http://worldworksgames.com/forum/ |
|
| Can't find GSD files for Mounts and Tabs... http://worldworksgames.com/forum/viewtopic.php?f=62&t=8467 |
Page 1 of 1 |
| Author: | krizzik [ 06-14-2010, 07:15 AM ] |
| Post subject: | Can't find GSD files for Mounts and Tabs... |
| Author: | Sacretis [ 06-14-2010, 09:13 AM ] |
| Post subject: | |
| Author: | krizzik [ 06-14-2010, 03:27 PM ] |
| Post subject: | |
| Author: | Solospirit [ 06-14-2010, 05:43 PM ] |
| Post subject: | |
| Author: | krizzik [ 06-14-2010, 06:09 PM ] |
| Post subject: | |
| Author: | Solospirit [ 06-14-2010, 07:46 PM ] |
| Post subject: | |
| Author: | krizzik [ 06-14-2010, 11:17 PM ] |
| Post subject: | |
| Author: | Bob_Runnicles [ 06-15-2010, 02:16 AM ] |
| Post subject: | |
Denny has been making some noise in another thread somewhere about the possibility of pre-cut TLX foamcore tiles, but I don't know how close that thought is to fruition.....Denny? Otherwise I can see what you mean, while the basic template shapes might be easy enough to cut by hand (they're just squares/rectangles after all) if you have a cutter it would seem to make sense to have a GSD if only to cut out the overall template piece from a sheet. Yes, once you mount it then you cut out the tabs etc, but I'm pretty sure you weren't asking to have the tabs cut out from the template before you mount it on the foamcore (unless I'm seriously misreading things). |
|
| Author: | krizzik [ 06-15-2010, 05:16 AM ] |
| Post subject: | |
| Author: | Solospirit [ 06-15-2010, 10:38 AM ] |
| Post subject: | |
Apologies...I misunderstood what you were trying to say and ended up answering the wrong question. Sry
|
|
| Author: | krizzik [ 06-15-2010, 09:09 PM ] |
| Post subject: | |
No worries, Solospirit, as your intentions were sound. Again, this issue has been somewhat resolved, I just wish that the option of having GSDs for these templates was at least available even if the majority of users may not end up using them. |
|
| Author: | phlidwsn [ 06-16-2010, 09:32 AM ] |
| Post subject: | |
| Author: | krizzik [ 06-16-2010, 10:00 AM ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|